Bissell Steam Mop Betriebsanweisung PDF herunterladen (Seite 8)

www.bissell.com 800.237.7691

Operations

8

Cleaning hard floors continued

1. When the ready light illuminates, begin

cleaning by slowly passing over surface

while pressing the steam on demand trigger

to emit steam as needed.

2. To sanitize an area of your floor, (attack

invisible germs and bacteria) place the

center of the Lift-Off Steam Mop over the

spot for a minimum 15 seconds, but no

longer than 20 seconds. For larger areas,

overlap swivel head placement.

3. When the Lift-Off Steam Mop stops emitting

steam, simply remove the water tank, refill,

and continue cleaning.

NOTE: upon first use of this steam

product or first use of a new filter,

the pump may make a "knock-

ing" sound while the filter fills with

water. This sound is normal and

may last up to one minute. Continue

to depress the trigger until the

knocking sound subsides and the

unit emits steam.

Steam cleaning all living areas

Stubborn messes that resist traditional

water and cleaning solutions can be

removed with steam. Toothpaste or hair

spray on the bathroom sink, soap scum

on sliding shower walls—steam makes

all these far easier to clean.

1. Fill the water tank with cool tap water or dis-

tilled/demineralized water and replace back

on Detachable Steam Pod.

2. Remove Steam Pod by pressing the pod

release button on the top of the carry handle

and pulling the pod out and away from the

lower base.

3. Remove cord from pod and connect the plug

to an appropriate outlet.

4. Remove hose from pod by pressing the clip

at the end of the hose where it connects to

the detachable pod.

5. Connect desired tool to the end of the hose.

6. When blue ready light turns on, the steamer

is ready to use.

7. To activte steam, press the pod release but-

ton on the top of the carry handle. To stop

steaming, release the pod release button.

WARNING:

Never put descaling, aromatic

(not including the BISSELL Eucalyptus

Mint water product), alcoholic or

detergent product) into the steam

cleaner, as this may damage it or

make it unsafe for use.

Tip:

During first use, it may

take several seconds for

the Lift-Off Steam Mop

to begin steaming. The

water needs to flow

through the filter to the

heater. This delay will

only occur during initial

use or when using a

new filter.

1 2 3 4 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare